Fuji Xerox DocuCentre-V C4475 User Manual

5 Tools
222
Tools
5
TCP/IP - Common Settings
Configure common settings to use TCP/IP.
 Primary Network (Type 2 (T2) model only)
When two Ethernet interfaces are used, the name of interface which works as the primary
network is displayed.
Note • The primary network is "Ethernet 1". You cannot set "Ethernet 2" as the primary network.
• This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
You cannot edit the setting from here.
 IP Mode
Allows you to select the TCP/IP operation mode.
Displays current IP mode.

IPv4 Mode
Select this option for IPv4.

IPv6 Mode
Select this option for IPv6.

Dual Stack
Select this option for an environment using both IPv4 and IPv6.
TCP/IP - Network Settings/ TCP/IP - Network Settings (Ethernet 1), TCP/IP - Network
Settings (Ethernet 2) (Type 2 (T2) model only)
Configure network settings other than common settings to use TCP/IP.
Important • Configuring same IP address for [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network
Settings (Ethernet 2)] is prohibited. When setting the same IP address to each Ethernet, contact our
Customer Support Center.
• Only LPD, Port9100, and SNMP ports are available for [TCP/IP - Network Settings (Ethernet 2)]. The
applications using any other ports such as Network Scanner Utility 3 may not work with the [TCP/IP -
Network Settings (Ethernet 2)] setting.
Note • We recommend you to specify different IP addresses between [TCP/IP - Network Settings (Ethernet
1)] and [TCP/IP - Network Settings (Ethernet 2)].
• The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [TCP/IP - Network Settings] is displayed. When two Ethernet interfaces
are used, [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)] are
displayed.
• For [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)], same
setting items as [TCP/IP - Network Settings] are displayed. You can configure individual settings for
each Ethernet interface.
• When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network
Name], the specified names are displayed instead of "Ethernet1" and "Ethernet2" of [TCP/IP -
Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)] respectively.
 IPv4 - IP Address Resolution
Allows you to select a method for obtaining the IP address, subnet mask, and gateway
address.

DHCP
The address, subnet mask, and gateway address will automatically be set via DHCP.

BOOTP
The address, subnet mask, and gateway address will automatically be set via BOOTP.

Fuji Xerox DocuCentre-V C4475 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-V C4475
Category	Printer
Language	English