Fujitsu AUXG12KVLA User Manual

4-5. E: 18. Wireless LAN adapter non-energized
Indicator
Indoor unit
Operation indicator 1 time flash
Timer indicator 8 time flash
Economy indicator Continuous flash
Error code E: 18
Wireless LAN
adapter
LED1 (green) Off
LED2 (orange) Off
Detective actuator
Indoor unit controller PCB
When the voltage (DC 12 V) does not output from the
controller PCB.
Wireless LAN adapter PCB
Forecast of cause
Indoor unit controller PCB failure
Wireless LAN adapter PCB failure
Wiring connection failure
Check point 1. Check the connection.
• Check any loose or removed connection of between the wireless LAN adapter PCB and con-
troller PCB.
-> If there is abnormal condition, correct it.
• Check the connection condition on the controller PCB.
-> If there is loose connector, open cable or mis-wiring, correct it.
↓
Check point 2. Check the wireless LAN adapter PCB and the controller PCB
Check voltage at CN12 (terminal 1—2) of main PCB.
(Power supply to remote controller)
• If it is DC 0 V, controller PCB is failure.
-> Replace controller PCB.
• If it is DC 12 V, wireless LAN adapter PCB is failure.
-> Replace the wireless LAN adapter and cancel the registration of air condi-
tioner on the mobile app.
After replacing the adapter, perform the pairing on the mobile app.
For the method of the mobile app, refer to "Mobile app setting method" on
page 03-73.
↓
End
4-5. E: 18. Wireless LAN adapter non-energized - (03-72) - 4. Troubleshooting with error code (For wireless LAN adapter)
TROUBLESHOOTING TROUBLESHOOTING

Fujitsu AUXG12KVLA Specifications

General

Brand	Fujitsu
Model	AUXG12KVLA
Category	Air Conditioner
Language	English