62
- Lithium ion Battery
1 Have a charged battery ready to install.
2 Shut down your notebook and disconnect the AC adapter.
3 While pushing the battery lock away from the battery, slide the battery latch towards the center of the system.
Lift the battery out of the bay at the lift point.
4 Insert a new battery into the bay, and press it down so that the latches click into place.
5 Plug in the AC adapter and turn the power on.
Hot-swapping Batteries
To hot-swap batteries in your battery bay follow these easy steps:
1 Plug an AC Adapter into the system and connect it to a power outlet.
2 While pushing the battery lock away from the battery, slide the battery latch towards the center of the system.
Lift the battery out of the bay at the lift point.
3 Insert a new battery into the bay, and press it down so that the latches click into place.
4 Turn the power on.
BE SURE TO PLUG IN AN AC ADAPTER PRIOR TO REMOVING THE BATTERY. THERE IS NO BRIDGE BATTERY PRESENT TO SUPPORT THE SYSTEM
WHILE THE BATTERY IS BEING REPLACED. IF YOU DO NOT USE AN AC ADAPTER YOU WILL LOSE ANY UNSAVED FILES.
I
F THE LITHIUM ION BATTERY CONNECTOR IS NOT FULLY SEATED, YOU MAY NOT BE ABLE TO USE YOUR NOTEBOOK OR CHARGE YOUR BATTERY.
To Next Page
Loading...
Need help?
General
