47
- Starting Your LIFEBOOK Notebook
When you power on your LIFEBOOK, it will perform a Power On Self Test (POST) to check the internal parts and
configuration for correct functionality. If a fault is found, your LIFEBOOK notebook will emit an audio warning and/or
an error message will be displayed.
See “Power On Self Test Messages” on page 88.
Depending on the nature of the
problem, you may be able to continue by starting the operating system or by entering the BIOS setup utility and
revising the settings.
After satisfactory completion of the POST, your notebook will load your operating system.
Boot Sequence
he procedure for starting-up your notebook is termed the Bootup sequence and involves your notebook’s BIOS. When
your notebook is first turned on, the main system memory is empty, and it needs to find instructions to start up your
notebook. This information is in the BIOS program. Each time you power up or restart your notebook, it goes through
a boot sequence which displays a Fujitsu logo until the operating system is found. During booting, your notebook is
performing a standard boot sequence including a Power On Self Test (POST). When the boot sequence is completed
without a failure and without a request for the BIOS Setup Utility, the system displays the operating system’s opening
screen.
The boot sequence is executed when:
• You turn on the power to your LIFEBOOK notebook.
• You restart your LIFEBOOK notebook from the Windows Shut Down dialog box.
• The software initiates a system restart; for example, when you install a new application.
DO NOT CARRY YOUR LIFEBOOK NOTEBOOK AROUND WITH THE POWER ON OR SUBJECT IT TO SHOCKS OR VIBRATION, AS YOU RISK DAMAGING
YOUR NOTEBOOK.
N
EVER TURN OFF YOUR LIFEBOOK NOTEBOOK DURING THE POWER ON SELF TEST (POST) OR IT WILL CAUSE AN ERROR MESSAGE TO BE
DISPLAYED WHEN YOU TURN YOUR LIFEBOOK NOTEBOOK ON THE NEXT TIME. See “Power On Self Test Messages” on
page 88.
To Next Page
Loading...
Need help?
General