61
- Memory Upgrade Module
Memory Upgrade Module
Your LIFEBOOK notebook can be upgraded to include up to 16 GB of in-slot high speed Double Data Rate (DDR3)
Synchronous Dynamic RAM (SDRAM). To increase your notebook’s memory capacity, you may install a larger memory
upgrade module.
Your LIFEBOOK notebook has two DIMM slots. The DIMM slots are located on different parts of the motherboard, and
only one can be accessed for upgrade.If you would like to increase the installed memory, you will need add a new
module to the empty slot. The memory upgrade must be a dual-in-line (DIMM) SDRAM module. To ensure 100%
compatibility, purchase the memory module only from the Fujitsu web store at us.fujitsu.com/computers.
Accessing the Memory Compartment
To gain access to the upgradable memory compartment, follow these steps:
1 Turn off power to your LIFEBOOK notebook, and remove any power adapter (AC or auto/airline) and
battery pack.
2 Place your LIFEBOOK notebook with the bottom facing up on a clean work surface.
• DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES SPECIFICALLY SHOWN IN THE DIRECTIONS
FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE.
• THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE (ESD). TO MINIMIZE RISK TO THE MODULE, OBSERVE
THE FOLLOWING PRECAUTIONS:
- B
EFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY.
- W
HEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS. BE CAREFUL
NOT TO TOUCH ANY COMPUTER TERMINALS OR COMPONENTS; THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS.
- B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES. EVEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP
STATES, DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM.
Y
OU MUST TURN OFF POWER BEFORE INSTALLING THE MEMORY UPGRADE MODULE.
To Next Page
Loading...
Need help?
General