Documents That Can Be Loaded Directly into the ScanSnap
Conditions for documents that can be loaded directly into the ScanSnap are as follows:
Document type Office paper, postcards, business cards
Plastic cards conforming to the ISO781A ID-1 type (54 × 86 mm/2.1 × 3.4 in.)
Paper weight
40 to 209 g/m
2
(10.7 to 55.7 lb)
Long page documents
52 to 127 g/m
2
(13.9 to 33.9 lb)
A8 size (52 × 72 mm) or less
127 to 209 g/m
2
(33.9 to 55.7 lb)
Plastic cards
0.76 mm (0.03 in.) or less (embossed cards can be used)
Paper size Width
50.8 to 216 mm (2 to 8.5 in.)
Length
50.8 to 360 mm (2 to 14.17 in.)
For long page (*1), up to 863 mm (34 in.)
*1: Scanning starts when you hold down the [Scan] button on the ScanSnap for 3 seconds or longer.
If you scan a magnetic card or IC card, do not bring the black magnetic part in
contact with the magnetic part of the ADF top section. Otherwise, the data on
the card may be lost.
ATTENTION
l The following types of documents must not be scanned:
- Documents attached with the metals such as paper clips or staples that can damage the inside
of the ScanSnap
Remove the metals for scanning.
- Documents on which the ink is still wet
Wait until the ink dries completely to scan these documents.
Documents to Scan
61