Furuno DS-8530 User Manual

2. WIRING
2-10
2.5 Transceiver Unit
2.5.1 How to fabricate the cables
Attach the SC lock and the packing (pre-attached to the cable entry on the transceiver)
to the cable before fabricating the cable. Please pay attention to the orientation of the
SC lock and packing.
Signal cable
The cables listed in the table below can be used for the transceiver unit.
Depending on the used cable, the type of the SC lock and the fixing location on the
cable are various, referring to the table below. The appropriate SC lock must be at-
tached at the appropriate location on the cable.
When using the optional junction box, fabricate the cable as in the previous figures.
Type of cable
Replacement to
OP65-4
Fixing location
on the cable
Remarks
TTYCYSLA-4
—
On the outer
sheath
TTYCSLA-4 Required On the armor No outer sheath
• TTYCY-4S
• TTYC-4S
—
On the inner
sheath
Cable for DS-80
Other cable
φ14.5 to 16.5?
Required
Attach the crimp-on lug to the core.
ShieldShield
PowerPower
Wrap the shield line on the inner sheath.Wrap the shield line on the inner sheath.
SignalSignal
Outer sheath*Outer sheath*
SC lock
(Fixing location is
different depending
on the cable type)
SC lock
(Fixing location is
different depending
on the cable type)
GasketGasket
ArmorArmor
Wrap the supplied conductive tape CCTE-20.
Wrap the both sides of the conductive
tape with vinyl tape.
Clamp on the conductive tape.Clamp on the conductive tape.
4040 66
190190
Inner sheath
Inner sheath
60
60
Sheath
Sheath
Armor
Armor
Gasket
Gasket
*: If the outer jacket is an armor, the sheath fabrication is as follows.

Furuno DS-8530 Specifications

General

Brand	Furuno
Model	DS-8530
Category	Marine Equipment
Language	English