To Next Page

To Previous Page

1. OPERATION

1-15

1.7.2 Target list (displaying target data)

1. At the plotter display, press the DISP key to show the TARGET LIST, which

lists all AIS targets and AIS-SARTs being detected by the FA-150.

Note 1:

The dangerous target list appears when there are dangerous

targets. You can switch to the target list by pressing ◄.

Note 2: If there is no data for the target selected, the message NO SEL

appears. Hit any key to escape.

Note 3: Targets are automatically sorted in range order (closest to furthest)

when no key is operated for 30 seconds. Target order is then updated every

five seconds.

Note 4: When AUTO SORT on the USER SETTINGS menu is OFF, the

range and bearing to a target are updated. However, target order is not

updated. To do this, press ◄, and targets are sorted in range order. “NOW

SORTING” is shown while sorting.

Note 5: To select a target on the plotter display, press ◄ or ► to select the

target then press the ENT key. Press ► to select from nearest to furthest;

◄ to select from furthest to nearest. The display then looks something like

the one shown at the top of the next page. If you wish to see other target

data, go to step 3 below.

Note 6: The information source is specified from obtained MMSI and ship's

name of an AIS target.

2. Use ▼ or

▲ to

select the target whose data you wish to view then press

the ENT key. The display then looks something like one of the displays

shown on the next several pages, according to type of target.

3. Use ▼ or

▲ to

scroll the display to see other data.

Furuno FA-150 User Manual

Other manuals for Furuno FA-150