Furuno FA-150 User Manual

APPENDIX
AP-2
(Continued from previous page)
DIAG-
NOSTICS
MONITOR TEST (Displays PROG NO. and BOOT NO.; checks ROM, SDRAM, LCD, controls.)
TRANSPONDER
TEST
PWR ON/OFF HISTORY (Log for time of equipment power on and off.)
TX ON/OFF HISTORY (Log for time of equipment transmission on and off.)
MEMORY CLEAR
ACTIVATE KEY (DEVICE ID, KEY[ACTIVATED])
FOR SERVICE (For service technician. Not accessible by user.)
MEMORY TEST (Displays PROGRAM NO.;
checks ROM, RAM, and MOT HW.)
GPS TEST
(Display PROGRAM NO. and checks internal GPS receiver.)
MONITOR CLEAR (YES, NO)
SET USER DEFAULT (YES, NO)
GPS COLD START (YES, NO)
NAV STATUS (00-15)
DESTINATION
ARRIVAL TIME
CARGO TYPE (10-99)
DRAUGHT&PERSONS
DATE
TIME
SELECT
EDIT
DELETE
[NAV STATUS]
key
VIEW CHANNEL (View power and channel settings of channel in use.)
EDIT CHANNEL
CHANNEL
SETTINGS
FROM MMSI
POWER (1W, 12.5W)
CH NO. CH-A, CH-B
MODE
CH-A, CH-B
ZONE (1-8 (NM)
Press [ENT] key to display.
CH AREA
RIGHT TOP
LEFT BOTTOM
LAT
LON
LAT
LON
SELECT NO. (0-9)
TIME (UTC)
FROM MMSI (HIGH SEA, MMSI, EMPTY)
TYPE (HIGH SEA, AIS, PI, DSC,
MANUAL, EMPTY)
DRAUGHT (0-25.5(m))
NO. OF PERSONS (0-8191)

Furuno FA-150 Specifications

General

Modulation	GMSK
Operating Temperature	-15°C to +55°C
Frequency	156.025 MHz to 162.025 MHz
Display	LCD
Frequency Range	156.025 MHz to 162.025 MHz
Current Consumption	1.5 A (max)