4. AIS OPERATION
4-5
[TT•AIS MENU]
1 BACK
2 AZ STAB
STAB HDG/STAB NORTH
3 AZ POLYGON
OFF/STAB GND/
STAB HDG/STAB NORTH
4 [TRIAL MANEUVER]
5 [TT
.
AIS SYMBOL]
6 [CPA AUTO ACTIVATE]
7 [AIS DISP FILTER]
8 [AIS LOST FILTER]
9 [TT LOST FILTER]
0 [ASSOCIATION]
[AIS DISP FILTER]
1 BACK
2 MAX RANGE
OFF/ON
0NM
3 MIN SHIP SPEED
OFF/ON
0.0kn
4 EXCEPT CLASS B
OFF/ON
5 MIN SHIP LENGTH
OFF/ON
0M
4.3 AIS Display Filter
If there are too many AIS targets on the screen you may wish to remove
unnecessary ones. You may remove sleeping targets A/B by distance from own
ship, speed, class and length. For example, you might want to remove slow
moving targets, as they normally do not require close monitoring.
1. Left-click the MENU box to open the menu.
2. Select 4 [TT
Æ”
AIS] to open the TT
Æ”
AIS
menu.
TT/AIS menu
3. Select 7 [AIS DISP FILTER].
AIS DISP FILTER menu
4. Set items 2-5 referring to the description below.
MAX RANGE: Any sleeping AIS targets class A/B beyond the range set here
will not be shown.
MIN SHIP SPEED: Any sleeping AIS targets class A/B slower than this
setting will not be shown.
EXCEPT CLASS B: Select ON to remove sleeping AIS targets class B.
MIN SHIP LENGTH: Any sleeping AIS targets class A/B whose length is
shorter than this setting will not be shown.
5. Push the right button twice to close the menu.
6. Select "DISP FILT" from the AIS DISP box.
Note: An AIS target whose data is currently displayed is not affected by the
filter setting.
If the AIS DISP box is operated
when all settings on this menu are
set for OFF, the setting of the AIS
DISP box becomes DISP ALL.
To Next Page
Loading...
Need help?
General
