1. RADAR OPERATION
1-74
4. If you have selected DEAD RECKONING do the following to enter position
manually. For GPS1 or GPS2, go to step 6.
a) Select 2 MANUAL L/L then push the scrollwheel. Enter latitude and longitude
position as follows.
b)
Roll the scrollwheel to set appropriate digit in the latitude field then push the
scrollwheel. (You may push the scrollwheel again to skip a place.) For
keyboard operation, press appropriate numeric keys then press the [ENTER
MARK] key.
c) Set longitude similar to how you set latitude then push the scrollwheel. (For
keyboard operation, press the [ENTER MARK] key.)
Note: Co-ordinate polarity may be switched by rolling the scrollwheel, or
pressing the [2] key.
5. To use a navigation device connected to radars via a LAN, set 3 SIO DATA
LAN OUTPUT to ON, then select LAN at 1 NAV AID.
6. Push the right button to close the menu.
Note: When the AIS function is active, DEAD RECKONING is shown in gray to
indicate that it is not available for selection.
To Next Page
Loading...
Need help?
General
