Furuno FELCOM 15 Service Manual

AP4.12 Connection check
AP4-32
AP4.12 Connection check
AP4.12.1 Checking by Ping command
Ping command is used for checking the connection between FELCOM 15 and the PC.
Type “ping” and IP address of FELCOM 15 in “Command prompt” on the PC. For
example, when IP address is “172.31.16.1”, type “ping 172.31.16.1”. When FELCOM
15 is connected to the PC correctly, the replay message (Reply from -) appears as
below. When the message “Request time out.” appears, check the network connection
and IP address of FELCOM 15.
This command is only available on the PC.
Example of reply message:
Reply from 172.31.16.1: bytes=32 time=10ms TTL=32
Reply from 172.31.16.1: bytes=32 time<10ms TTL=32
No reply message:
Request time out.
Set “Device” to 10 Mbps and Half Duplex when the LAN card is 100 Mbps.
The FELCOM 15 LAN port specification is 10 Mbps and Half duplex.
Other commands
- ipconfig /all : Displays all commands about TCP/IP
- netstat –a : Displays all active TCP connections and the TCP and UDP ports on
which the computer is listening.
Replay message
No reply message

Furuno FELCOM 15 Specifications

General

Brand	Furuno
Model	FELCOM 15
Category	Marine Radar
Language	English