4.1 System menu (F8)
4-3
NAV Port OFF/ EXT/ INT
- INT: Sets when the built-in GPS is installed
(GN-79: option)
- EXT: Sets when the external GPS is connected.
Note that the alarm is released when the NMEA
data is stopped. See page 2-15.
- OFF: Inputs manually the position data from [F9].
Note that the alarm is released when the data is
not updated every 4 hours.
INT
The received message is output to the Terminal
unit: IC-215 only.
Active Port
ALL
The transmission and the reception is available
from the Terminal unit: IC-215, the PCs connected
to DTE and LAN port.
INT
EXT
INT+EXT
Message
Output Port
AUTO
Setting for the message output. Only valid when the
setting of “Active Port” is ALL.
- INT: Outputs to the Terminal unit: IC-215.
- EXT: Outputs to DTE and LAN port.
- INT+EXT: Outputs to the IC-215, DTE and LAN
port.
- AUTO: Outputs to the ports according to Sub
Address.
Note) Sub Address;
IC-215 and LAN port: 000
DTE: 001
INT
EGC Output
Port
INT+EXT
Setting for the message output. Only valid when the
setting of “Active Port” is ALL.
- INT: Outputs to the Terminal unit:IC-215.
- EXT: Outputs to DTE and LAN port.
- INT+EXT: Outputs to the IC-215, DTE and LAN
port.
IP Address Default setting: 172.31.16.1
Subnet mask Default setting: 255.255.0.0
DHCP
With DHCP turned on, IP address and subnet mask
are automatically assigned when a DHCP server
resides on a LAN. The default DHCP setting is
OFF.
Network
(See page AP4)
Gateway
Set gateway IP address when mail is sent from a
PC on a different network through a router.
SMTP Enable IP
Address
Specify the IP address of the PC which is to be
used to send and receive e-mail. A PC not specified
cannot send e-mail but it can receive e-mail. If no
IP address is specified, all PCs connected to the
LAN can send and transmit e-mail.
Send Limit Size 2,4,6,8,10,16,32KB
UUENCODE;
Using the default setting, mail (MIME encoded) sent
from a PC in a network is encoded with
UUENCODE. For Inmarsat C use UUENCODE.
Mail Gateway
(See page AP4)
Attach
BINARY