Furuno NXT-600 - How to Connect the Transducer Cable

2. WIRING
7
2.2.2 How to connect the transducer cable
This procedure shows you how to connect the transducer cable.
1. Open the cover - grasp the cover at two sides, spread the cover slightly and lift.
2. Loosen four screws to remove the shield cover.
3. Detach the two WAGO connectors (TB3, TB4) inside the equipment.
4. Unfasten the sealing nut from the super gland for the transducer cable.
WAGO connector
opener
WAGO connectors
TB4
TB3
Sealing nut
Super gland