75
＜
Linkage Menu
＞
+(/,&237(5
$,53/$1(*/,'(5
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
/,1.$*(0(18
The Linkage Menu has all of the functions you will
need to perform model addition, model type selection,
frequency setting, end point setting, and other model
basic settings.
The functions which can be selected depend on which
model type you are using. A typical menu screen is
shown below.
/LQNDJH0HQXIXQFWLRQVWDEOH
Ɣ6HUYR0RQLWRU Displays the servo test and operation position
Ɣ0RGHO6HOHFW Model addition, call, deletion, copy, model name setting
Ɣ0RGHO7\SH Model type, wing type, switch type, etc. selection
Ɣ3LFWXUH Picture selection and setting for each model
Ɣ6RXQG Sound recording and playback
Ɣ6\VWHP7\SH System selection, receiver link, telemetry.
Ɣ)XQFWLRQ Channel assignment of each function can be changed
Ɣ6XE7ULP Adjusts the neutral position of each servo
Ɣ6HUYR5HYHUVH Servo direction reversal
Ɣ)DLO6DIH Fail safe function and battery fail safe function setting
Ɣ(QG3RLQW$79 Servo basic rudder adjustment and limit setting
Ɣ7KURWWOH&XW Stops the engine safely and easily (airplane and helicopter only)
Ɣ,GOH'RZQ Lowers the idle speed of the engine (airplane and helicopter only)
Ɣ6ZDVK5LQJ/LPLWVWKHVZDVKWUDYHOZLWKLQD¿[HGUDQJHWRSUHYHQWOLQNDJHGDPDJHKHOLFRSWHURQO\
Ɣ6ZDVK Swash AFR and linkage correction function (helicopter only)
Ɣ7LPHU Timer setting and lap time display
Ɣ'LDO0RQLWRU Dial, slider, and digital trim position display and setting
Ɣ)XQFWLRQ1DPH Function Name can be changed
Ɣ7HOHPHWU\ Displays various data sent from the receiver
Ɣ6HQVRU Various telemetry sensors setting
Ɣ6HQVRU1DPH Change of a sensor name
Ɣ7HOHPHWU\6HWWLQJ Data logging of telemetry
Ɣ:DUQLQJ Warning sound and vibration setting
Ɣ'DWD5HVHW Model memory data reset (by various item)
Ɣ8VHU0HQX Create an original menu that you often use
To Next Page
Loading...
Need help?
General
