WARNING! Reverse must be en-
gaged when the machine has stopped.
Hydrostatic transmission
4.31 BRAKE PEDAL (Fig. 4.3 no.31)
4.32 CLUTCH PEDAL (Fig. 4.3 no.32)
speed.
-
ing that increasing the pressure on the
WARNING! Reverse must be en-
gaged when the machine has stopped.
NOTE If the drive pedal is used, wheth-
er forwards or for reverse, when the parking
brake (4.4) is engaged, the engine stops.
4.33 HYDROSTATIC TRANSMISSION
DISENGAGEMENT LEVER
(Fig. 4.3 no.33)
«A
-
«B
-
IMPORTANT To avoid damaging the
transmission unit, this operation must be car-
ried out only when the engine has stopped
with the pedal (4.32) at position «N».
5. OPERATING INSTRUCTIONS
5.1 SAFETY RECOMMENDATIONS
WARNING! If the machine is likely to
be used mostly on sloping ground (never
steeper than 10°), fit counterweights (sup-
plied on request (see 8.6) beneath the
cross-member of the front wheels. These
improve stability at the front and reduce the
chances of tipping over.
IMPORTANT All the references relating to
the positions of controls are those described in
chapter 4.
5.2 WHY THE SAFETY DEVICES CUT IN
a
b
– the grass catcher is lifted or the rear dis-
-
5.3 PRELIMINARY OPERATIONS BEFORE
STARTING WORK
5.3.1 Seat adjustment (Fig. 5.1)
-
5.3.2 Tyre pressure (Fig. 5.2)
-
-
-
adjust the pressure to the indicated values.
5.3.3 Filling with oil and fuel
NOTE The type of oil and fuel to use is given
To Next Page
Loading...
Need help?
General
