Contents [ hide
1 Introduction
1.1 Getting Started
1.2 Charging the Device
1.3 Installing the Out-Front Mount
1.4 Tips for Installing the Taillight
1.4.1 Installing the Seat-Post Mount
1.4.2 Installing the Multi-Location Mount
1.5 Varia HL Device Overview
1.6 Varia TL Device Overview
1.7 Turning On the Device
1.8 Operating Modes
1.9 Bike Light Status LEDs
2 Device Settings
2.1 Customizing Varia Device Settings with Your Edge
1000
3 Wireless Remote Control
3.1 Device Overview
3.2 Status LED
3.3 Pairing the Remote with Your Varia Device
3.4 Using the Mounts
3.5 Replacing the Battery
4 Device Information
4.1 Specifications
4.1.1 Headlight Specifications
4.2 Device Care
5 Troubleshooting
5.1 Resetting the Device
5.2 Thermal Safety Shutdown
5.3 Replacement O-rings
5.4 Support and Updates
5.5 Updating the Software
5.6 Getting More Information
6 Appendix
6.1 Software License Agreement
6.2 File Downloads
6.3 References
6.4 Related Manuals
Introduction
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Always consult your physician before you begin or modify any exercise program.
Getting Started
You can use the Varia HL (headlight) and Varia TL (taillight) alone, with the optional wireless remote, or with your compatible Edge ® device. This list provides an
overview of the installation and setup tasks.
Charge the device (Charging the Device, page 1).
Install the headlight using the out-front mount (Installing the Out-Front Mount, page 1).
Install the taillight using one of the included mounts:
◦ Install the seat-post mount (Installing the Seat-Post Mount, page 1).
◦ Install the multi-location mount (Installing the MultiLocation Mount, page 2). TIP: If you are using two taillights as turn signals, you can install two multi-
location mounts on the seat stays of your bike.
NOTE: The turn signal feature is available on the Varia TL 300 only.
If you are using the wireless remote, pair the devices (Pairing the Remote with Your Varia Device, page 4).
If you are using the wireless remote, install it on your bike stem or handlebar (Using the Mounts, page 4).
If you are using a compatible Edge device, pair the devices (Pairing Varia Bike Lights with Your Edge 1000, page 3).
If you are using a compatible Edge device, customize the bike light settings (Customizing Varia Device Settings with Your Edge 1000, page 3).
Charging the Device
NOTICE
To prevent corrosion, thoroughly dry the USB port, the weather cap, and the surrounding area before charging or connecting to a computer.
The device is powered by a built-in lithium-ion battery that you can charge using a standard wall outlet or a USB port on your computer.
NOTE: The device does not charge when outside the approved temperature range (Specifications, page 5).
1. Pull up the weather cap from the USB port.
2. Plug the small end of the USB cable into the USB port on the device.
3. Plug the large end of the USB cable into an AC adapter or a computer USB port.
4. Plug the AC adapter into a standard wall outlet.
5. Charge the device completely.
The status LED flashes green while charging. The status LED is solid green when charging is complete.
Installing the Out-Front Mount
To Next Page
Loading...
Need help?
General
