Keep the battery away from children.
Never put batteries in your mouth. If swallowed, contact your physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate material. Special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
CAUTION
Contact your local waste disposal department to properly recycle the batteries.
Before you can replace the battery, you must have a small Phillips screwdriver, a small flat screwdriver, and a CR2032 lithium coin-cell battery.
1. Using a Phillips screwdriver, remove the three screws from the backplate1.
2. Remove the back plate from the remote.
3. Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and contacts from damage.
4. Carefully pry the battery from the back plate.
5. Install the new battery into the backplate with the positive side facing down.
6. Verify the gasket 2 is fully seated in the groove.
Device Information
Specifications
Headlight Specifications
Battery type Rechargeable, built-in lithium-ion battery
Battery life
Up to 2.5 hr. in high mode
Up to 5 hr. in flash mode
Flash mode is available on the Varia HL 500 only
Operating temperature range From -15° to 50°C (from 5° to 122°F)
Charging temperature range From 0° to 40°C (from 32° to 104°F)
Radiofrequency/protocol 2.4 GHz ANT+ wireless communications protocol
Water rating IEC 60529 IPX7′
Varia HL 500 LED luminous flux and peak illuminance 600 Im 95 lx
Varia HL 501 LED luminous flux and peak illuminance 300 Im 65 lx
Headlight Light Intensity Modes
To Next Page
Loading...
Need help?
General
