11
1. Position pedestal bracket in correct orientation; refer to imprint on bracket.
. Attach the pedestal by rst inserting the stationary tabs on the pedestal into the
upper set of slots on the bottom of the base and then push the pedestal down until
it snaps into place.
3. Check the handset hook to make sure it is inserted so the imprint reads DESK.
Remove and turn over if necessary.
1. Position pedestal bracket in correct orientation; refer to imprint on bracket.
. Attach the pedestal by rst inserting the stationary tabs on the pedestal into the
lower set of slots on the bottom of the base, and then push the pedestal down until
it snaps into place.
3. Slip the mounting holes on the pedestal over the wall plate posts and rmly slide
the unit into place. (Wall plate not included.)
4. Check the handset hook to make sure it is inserted so the imprint reads WALL.
Remove and turn over if necessary.
1. Connect one end of the coiled handset cord to the jack on the side of the base.
. Connect the other end of the coiled cord to the jack on the handset, then place the
handset in the base cradle.
This section shows you how to set up your answering system to receive incoming
calls. Before you begin the setup, you must turn on the answering system.
• Press the button to turn the answering system on and off.
ANSWERER OFF
If you need additional assistance, press and hold the button on the base and
follow the voice instructions.
To Next Page
Loading...
Need help?
General
