ADTS TOUCH
K0553 Revision D 16 [EN] English
5) Measure/Control mode: toggle function. The blue indicator identifies the currently selected
function:
- Indicator left: Measure mode.
- Indicator right: Control mode.
6) Pressure/Aeronautical units selection: toggle function. The blue indicator identifies the
currently selected function:
- Indicator left: Pressure units.
- Indicator right: Aeronautical units.
7) Pressure mode selection: toggle function. The blue indicator identifies the currently
selected function: With pressure units selected:
- Indicator left: Ps (static) and Pt (pitot) (absolute pressures).
- Indicator right: Ps (static) and Qc.
With Aeronautical units selected:
- Indicator left: ALT (altitude) and CAS (calibrated air speed).
- Indicator right: ALT (altitude) and Mach speeds.
To turn the ADTS Touch off, the ON/OFF key (1, Figure 5-3) should be pressed until the display
goes blank. A momentary press will be ignored. To turn the unit ON, press the ON/OFF key until
the display appears.
To Next Page
Loading...
Need help?
General
