Section 2
‘.
DESCRIPTION, COMPONENT
IDENTIFICATION, and SPECIFICATION
The
AF900M$
Drive is avarlable In ratrngs of
l/4
to 3 hp 200-230
Vat
single phase and
l/4
to 5 hp 230
&
460
Vat
three phase. The
AF600M$
Drive incorporates
sinusordral
PWM Scalar power control
with
automatrc
voltage
regulator function. The AFSOOM$ Drives are housed
In
a NEMA
1
type enclosure for either open or panel mounting
and all Drives are furnished with a detachable cover to allow ease of accessing control and power wrnng.
Drive operation and Function Code setting
IS
performed from the “Keypad Panel” that features a Digital Monitor Drsplay
and 6 dual function keys. The 6 dual function keys are used for Drive programming and operation
General data and specrfrcation for each Drive IS
listed on the nameplate attached to the Drive
Refer to TABLE
1,
page 2-4 for complete AF-300M$ Drive specrfication listing.
INSPECTION PROCEDURES UPON DELIVERY
Upon receipt of your Drive, inspect the equipment for the followrng items.
1. Check the nameplate to insure that the specrfrcations correspond to those
ordered, and to applicatron requirements
2. Inspect the unit for any damage that may have occurred during shipment.
-
If shipping damage
IS
found or the wrong Drive IS received, contact the
distributor from which the equipment was purchased
MODEL NO.
SERIAL NO.
INPUT:
VOLTS
AMPS
FREQ (HZ)
PHASE (S)
INSTRUCTION
BOOK GEL100313
OUTPUT
VOLTS
FREQ RANGE (HZ) 0
-
400
HP
AMPS CONT.
PHASE
ROTATION
MAX 60 SEC. AMPS
GE Motors
&
lndustrtal
Systems, Fort Wayne, IN Made
I”
Japan
MODEL NO.
6KAF3
__ ___
M$Al
LAF
-300
MICRO-$AVER
TM
Drive
002
-
2HP
003
-
3 HP
005
-
5 HP
1 -Single Phase 3-three phase
2-(230~)
4-(460~)
All models are UL Listed and CSA Approved
Figure 2-1.
NAMEPLATE DATA IDENTIFICATION
2-1
To Next Page
Loading...
Need help?
General
