– 9 –
Overview
What to expect
It is normal for cool air to blow out the vents on the
rear shroud of the water heater.
The air is moved through the water heater by a fan
located at the back of the water heater near the top.
Adjusting water temperature
The water heater is preset to 120°F; the standard
setting for a new water heater.
This temperature is easily adjusted by touching
either the UP or DOWN arrow, then touching ENTER.
You may also refer to the use and care manual
included with the product for detailed instructions.
Cleaning the air lter
The water heater has an air lter that is removable
and occasionally needs to be cleaned.
When the lter requires cleaning, the red light above
the lter button will be illuminated and an audible
beep will sound.
To remove the lter, squeeze 2 tabs and lift the lter
from the top of the unit. The lter can be wiped
clean with a damp rag or rinsed with warm water.
The cost of operating a traditional water heater has been reduced because this water heater uses heat
pump technology. The heat pump removes heat from the surrounding air, heats the water, and moves the
cooler air back into the room.
(Continued Next Page)
WARM AIR
COOL AIR
ENTER
F
C
DAYS
HEAT PUMP (ONLY)
HYBRID
HIGH DEMAND
ELECTRIC (FAN OFF)
VACATION
Hold for
°F/°C
Hold to Override
PS-Power Saver
Hold to
Reset
POWER
FILTER
MODE
SAVER
To Next Page
Loading...
Need help?
General
