Chapter 3: Configuration and commissioning
32 Kilsen KFP-CF Series Installation Manual
Display Menu Values Operating mode
Zone type Mixed
Automatic
Manual
All
Access level 2 password 0 to 4444 All
Access level 3 basic password 0 to 4444 All
Access level 3 advanced
password
0 to 4444 All
Control panel PCB serial number Read only All
Auxiliary 24 V reset ON/OFF All
Sounder operation during a zone test
Use this menu to configure the sounder operation during a zone test. The default
setting for all operating modes is ON.
To configure the sounder operation during a zone test:
1. Set the display as shown below, and then press Enter.
The Sounders Start/Stop LED flashes quickly to indicate that the sounder
operation during a zone test configuration menu is active.
7. Select a value using the value selection buttons (2 and 4).
8. Press Enter.
9. Save your changes.
The available settings for this feature are shown below.
Display Description
The internal buzzer and sounders sound for three seconds
when an alarm is activated in a zone test.
The internal buzzer and sounders do not sound when an
alarm is activated in a zone test.
To Next Page
Loading...
Need help?
General
