NX-148E LCD Code Pad Installation and Setup Manual 19
Arming and Disarming Multiple Areas
To arm/disarm multiple areas, enter a code that has arm/disarm
authority for all
of the areas to be armed/disarmed. A display similar to
the one on the left will appear on the LCD screen.
Top line of display = disarmed areas to which this code has access
Bottom line of display = areas that are armed
Table 8-1 List of Possible Conditions
LCD Display
If area number is …
Condition
Blank
Blank
Area not used or authorized
Dash (-)
Dash (-)
Area not ready
Flashing
Dash (-)
Area ready to force arm
Dash (-)
Flashing
Area armed instant
Area #
Dash (-)
Area disarmed & ready to arm
Dash (-)
Area #
Area is armed
To disarm all of the areas, press
To arm all of the areas, press
To toggle a single area between the armed and disarmed conditions, press
[area number]. For
example, if area 4 is armed,
will disarm area 4. If area 4 is disarmed, will arm it.
To control the individual areas, refer to the following section ‘Operating Individual Areas in the Multi-
Area Mode’.
Operating Individual Areas in the Multi-Area Mode
Enter a code that is a valid arm/disarm code for the area you wish to operate.
12-45-78 Disarm º
--3-56-- Arm º
Only the areas authorized by this user code will appear.
To toggle between the armed and disarmed states on an individual area, press [area number].
To operate an individual area, enter the number of the area you wish to operate. The LCD code pad
will now operate as a single area code pad. All keys and functions entered will affect this individual
area only. The lights and LCD display represent the status of that area only. The word ‘System’ will
be replaced with the word ‘Area [no.]’. The following is an example of this feature.
Press # to exit.
Area 5 Ready
Type code to arm
Area 5 is selected and Area 5 is ready to arm.
Press # # to exit the individual area mode.
12-45--8 Disarm º
--3--67- Arm º
To Next Page
Loading...
Need help?
General
