Usingthe self-cleaning oven.
The oven door must be closed and all controls set correctly for the cycle to work properly.
ELF
CLEAN
DELAY
START
START
,'_.j
How to Delay the Start of Cleaning
Make sure tile clock shows tile correct
time of (lax:
[] Touch tile SELFCLEANpad.
[] Using tile nmnber pads, enter tile
desired clean time.
[] Touch the DEL4YSTART pad. The
earliest start time you can set will
appear in tile (lispla).
[] Using the number pads, enter tile
time of day you want tile clean c_cle
to St;lI't,
[] Touch tile START pad.
The door locks automatically: Tile display
will show tile start time. It will not be
possible to open tile oven door until tile
temperature drops below tile lock
temperature and the LOCKED DOOR light
goes off'.
_A]/en the LOCKED DOOR light is off, open
tile door;
After a Clean Cycle
Y)u mm notice some white ash in tile
oxen. _4ipe it up with a damp cloth atter
tile o_,en cools.
ff white spots remain,remove them with a
soap-filled scouringpad and rinse thoroughiy
with a vinegarand water ml)_ture.
These deposits are usually a salt residue
that cannot be removed bv tile clean cycle.
If tile oven is not clean after one clean
c'_cle repeat tile c)cle.
You cannot set tile oven flw cooking until
tile o_,en is cool enot/oh for tile door to
unlock.
While tile oven is selFcleaning, you can
touch tile CLOCK pad to display tile time
of day. To rettlrn to tile clean COtlntdown_
touch tile COOKING TIME pad.
If tile shelves become hard to slide,
apply a small amount of vegetable oil or
cooking oil to a paper rowel and wipe
the edges ot the oven shelves with the
paper towel.
3O
To Next Page
Loading...
Need help?
General
