4-9
4.2 Programmable Parameter Groups
Parameter Group No.
Description
Group 00 Basic parameters
Group 01 V/F Pattern selections & setup
Group 02 Motor parameters
Group 03 Multi function digital Inputs/Outputs
Group 04 Analog signal inputs/ Analog output
Group 05 Preset Frequency Selections.
Group 06 Auto Run(Auto Sequencer) function
Group 07 Start/Stop command setup
Group 08 Drive and motor Protection
Group 09 Communication function setup
Group 10 PID function setup
Group 11 Performance control functions
Group 12 Digital Display & Monitor functions
Group 13 Inspection & Maintenance function
Parameter notes for Parameter Groups
Parameter can be adjusted during running mode
Cannot be modified in communication mode
Does not change with factory reset
To Next Page
Loading...
Need help?
General