gefran GFXTERMO4 User Manual

32
880397M_MSW_GFX4-GFXTERMO4_08-2018_ENG
ALARM SBR - ERR (probe in short or connection error)
This alarm is always ON and cannot be deactivated. It controls correct functioning of the probe connected to the main
input.
In case of broken probe:
- the state of alarms AL1, AL2, AL3 and AL4 is set based on the value of parameter rEL;
- control power control is set to the value of parameter FAP.
Identification of the type of break detected on the main input is contained in Err.
9
bit
STATE OF INPUT
IN SBR
OFF = -
ON = Input in SBR
R
Enable alarm
229
rEL
R/W
Fault action
(definition of state in case
of broken probe)
Sbr, Err
Only for main input
0
Alarm Alarm Alarm Alarm
1 2 3 4
0 OFF OFF OFF OFF
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
4 OFF OFF ON OFF
5 ON OFF ON OFF
6 OFF ON ON OFF
7 ON ON ON OFF
8 OFF OFF OFF ON
9 ON OFF OFF ON
10 OFF ON OFF ON
11 ON ON OFF ON
12 OFF OFF ON ON
13 ON OFF ON ON
14 OFF ON ON ON
15 ON ON ON ON
Table of probe alarm settings
228
fa.p
R/W
Fault action power
(supplied in conditions of broken probe)
-100,0 ..100,0 %
0,0
see: HOT RUNNERS CONTROLI
Read state
85
Err
R
Error code in self-diagnostics
of main input
See: Table of error codes
FUNCTIONAL DIAGRAM
State of variable Ou.P
Power control
(PID output)
Output
power
limit
See outputs
Power limit for Fault
Action (FA.P)
Power
control.
Select LOC /
REM (D1G.,
d1G.2)
Power limit for LBA
alarm (Lb.P)
Average power for
power alarm
Manual
power/remote
(auxiliary analog input)
Manual power
Auxiliary
analog input
function
(tP.2)

gefran GFXTERMO4 Specifications

General

Brand	gefran
Model	GFXTERMO4
Category	Controller
Language	English