To Next Page

To Previous Page

PRINTED IN U.S.A. 65 50960066/AP0813

This Maintenance Interval Chart was developed to match the Service and Storage chapter of this manual. Detailed

information on each service procedure are in the Service and Storage chapter. A Maintenance Log follows the

Maintenance Interval Chart for recording the maintenance procedures performed. Recording the 10-Hour (or

Daily) service procedures would be impractical and is therefore not recommended.

IMPORTANT: Under extreme operating conditions, more frequent service than the recommended inter-

vals may be required. You must decide if your operation requires more frequent service.

Chapter 10

MAINTENANCE

SERVICE PROCEDURE 10 Hours 50 Hours 100 Hours 250 Hours

(or Daily) (or Weekly) (or Quarterly)

Checking Fuel Tank Level l

Checking Fuel Filter/Water Separator l

Checking Engine Oil Level l

Checking Coolant Level l

Checking Radiator for Debris l

Checking Hydraulic Oil Level l

Checking Brake Reservoir Level l

Checking Tire Pressures l

Checking Wheel Nut Torque l

Checking Instruments Operation l

Checking General Machine Operation and Condition l

Lubricating Grease Points l

Draining Fuel Filter/Water Seperator l

Change Engine Oil and Filter l

Change Hydraulic Return Filter Element l

Checking Axle Oil Levels l

Changing Engine Oil and Filter l

Changing Fuel Filters l

Checking the Battery l

Checking Boom Slide Pads Wear and Clearance l

1 - On new machines, or when a wheel has been removed, until 450 ft.-lbs. (610 Nm) is maintained.

2 - On new machines, after first 50 hours; every 250 hours thereafter.

3 - On new machine, after first 100 hours; every 500 hours thereafter.

MAINTENANCE INTERVAL CHART

Gehl RS5-19 User Manual

Questions and Answers: