Gima multiCare-in User Manual

20
Substituting the batteries
The multiCare-in instrument houses two lithium batteries 3V
(type CR 2032).
If the battery icon is blinking, the charge is low and the battery
must be replaced before taking a measurement.
Always insert a new battery and not a used one.
Shut down the instrument before removing the battery.
Check out the new battery to see if it is of the right type before
placing.
How to change the battery:
• Open the sliding rear panel of the instrument (1).
• Remove the battery from the plastic holder (2).
• Place the new battery so that the type is readable. The negative side
of the battery must be at the top (3).
• Close the back cover until a click is heard.
Flat batteries can be disposed of through recycling centers.
Note
If the battery is replaced or simply removed for more than 60 seconds,
it is necessary to set time and date again.
Manuale MCIN UK_ED2013 APRILE MFAP Definitivo.indd 20 13/06/2013 16:52:48

Gima multiCare-in Specifications

General

Brand	Gima
Model	multiCare-in
Category	Personal Care Products
Language	English