Description 9
Cod. 598144
Rev. 11/0717
1. INTRODUCTION AND APPLICATION
This manual contains the OPERATION and ADVANCED USE MODE instructions for washing machines with
COIN CONTROL system with or without extra options.
Application
This manual applies to the following models:
HS, EH, RMS610, REM025 models with software version 31 or higher
RMS, RMG and REM models with software version 65 or higher
2. DESCRIPTION
Washer extractor designed to wash or treat fabric in a water bath.
Control designed primarily for use in coin-op laundries.
2.1. Intended use of the washing machine
This machine has been made and designed for washing or treating textile materials in a water bath. These textile
materials must be free of flammable or explosive products. Unless approved by the manufacturer in writing, it is
not considered appropriate for any other use.
Under-loading as well as overloading is not recommended. Always endeavour to match the capacity of the
machine.
It is not advisable to insert bags full of laundry. Where necessary, load the machine up to its set limit.
It is not recommended to spin carpeting, canvas or waterproof fabrics.
2.2. Construction characteristics
HIGH SPEED MODELS (HS / EH). Washing machines capable of spinning at a speed higher than 350G
(280G in model HS-6008/EH020) and up to 400G without needing to be bolted down. The design of its
suspension system cushions up to 95% of the vibrations produced during the spin cycle.
MEDIUM SPEED MODELS (RMS/REM/RMG). Hard-mount construction. They have to be bolted down to
the floor.
- Approximate spin speed: 125G, 150G, on models RMS, REM.
- Spin speed: 200G on models RMG.
Stainless steel inner and outer drum. The openings in the drum blades promote the uniform distribution of
bath water and improve the yield of the washer both during the wash and the rinse cycles.
The drum rotation is produced by an asynchronous AC motor controlled by an inverter.
The hot and cold water connections have a safety mechanism to prevent contaminating by back-flowing
into the general drinking water system.
Large capacity drain valve. (Option for pump drainage in models HS-6008/EH020).
Water inlets and all product dispensers made using a common collector with an anti-siphon mechanism.
Option for heating the bath using electric heaters or steam injection.
To Next Page
Loading...
Need help?
General
