Goodwe UT Series User Manual

20
05 Installation User Manual V1.0-2023-03-20
The following tools are recommended when installing the equipment. Use other auxiliary tools
on site if necessary.
Installation Tool Requirements
Goggles Safety shoes Safety gloves Dust mask
Diagonal pliers
Marker Level Heat shrink tube Rubber hammer Vacuum cleaner
Torque wrenchCable tie
1500V
multimeter
Wire stripper Hammer drill Heat gun
DC terminal
crimping tool
5.2 Inverter Installation
5.2.1 Moving the Inverter
CAUTION
Move the inverter to the site before installation. Follow the instructions below to avoid
personal injury or equipment damage.
1. Consider the weight of the equipment before moving it. Assign enough personnel to move
the equipment to avoid personal injury.
2. Wear safety gloves to avoid personal injury.
3. Keep balance to avoid falling down when moving the equipment.
Socket wrench
M8/M12
M6/M5/M3

Goodwe UT Series Specifications

General

Brand	Goodwe
Model	UT Series
Category	Inverter
Language	English