Installation
12 3A3320E
Installation for XP-hf System
with Xtreme XL Motor
The procedures in this section are specific to each
component of the XP PressureTrak. For sprayer
installation instructions, refer to your sprayer operation
manual.
1. Perform Pressure Relief Procedure. See your
XP-hf Proportioner manual.
2. Remove the two top bolts (L) on the XL motor
manifold. Use the bolts to install the XP-hf
PressureTrak module.
3. Remove the plug (126) and 0-ring (125) by
removing the retaining ring (127).
4. Remove two right side bolts (23) from the XL motor
valve.
5. Install solenoid (8) into the solenoid hole.
6. Bolt down the solenoid holding bracket (17) with two
bolts while pushing the bracket to the left to hold the
solenoid tight in the hole.
7. Insert o-ring (19) on pressure sensor (7). Lubricate
o-ring and install into the A side (blue) of the
manifold. Torque sensor nut to 40-50 in-lb (54-67
N•m). Insert o-ring (19) on pressure sensor (7).
Lubricate o-ring and install into the B side (green) of
the manifold. Torque sensor nut to 40-50 in-lb
(54-67 N•m).
8. Install the pressure sensor harness (XD) through
clamp (20) and secure to the frame with screw (4).
9. Remove screws (9) to slide out module (6).
10. Connect the battery to the battery terminals.
11. Slide the module (XA) into the channel of the
housing (XB) and secure with two screws (9).
To reduce the risk of skin injection and shock, shut
down the XP Sprayer before installing your XP
PressureTrak. Follow the Shutdown and Pressure
Relief procedures in the XP Sprayer operation
manual.
To Next Page
Loading...
Need help?
General
