2
Energy Recovery Ventilation System
WARNING
• Installation should be done by qualied technicians. Never install, move or retrot the unit by yourself.
Improper installation could cause accidents such as falling, electrocution and res.
• This product should be installed strictly in accordance with this manual.
• Electric wiring should be performed as per your state or local codes and regulations. Poor capacity and
improper wiring of power lines poses electrocution and re hazards.
• A protective net is required at the air vent. Bird nests and other foreign matters should be removed to
prevent oxygen decit.
• The outdoor air inlet/outlet should be kept far away from the vent where inammable gas will be
discharged to prevent indoor oxygen decit.
• The air inlet should be where the discharged air does not return to avoid polluting the indoor air.
• The unit should be installed where it is strong enough to withstand the unit.
• The grounding wire cannot be connected with water pipes, lightning rods or telephone lines. Improper
grounding could lead to electrocution.
• Cut o the power supply though the main circuit breaker before repairs, maintenance or servicing to
prevent electrocution.
• Never insert the nger into air vents to avoid personal injury when fans run at a high speed.
• Ventilate the room by opening the windows if inammable gas leaks, otherwise spark produced by the
contactor could lead to explosion or re.
• Keep the unit working under the rated voltage to prevent electrocution or re.
• When any unusual situation arises, stop the unit and cut o the power supply to prevent electrocution or
re. If you need assistance, contact your local Gree service center.
• Animals or plants should not close to air vents to avoid harms.
• Metal pipes should be insulated before going through metal structures of a building to prevent
electrocution or electrical leakage.
CAUTION
• Do not put the burner towards air vents to avoid inadequate burning.
• The top surface of the unit should be water-proof to prevent electrocution.
• Do not release inammable gas near this unit to avoid re hazard.
• Operate the swtich corrrectly and never repeat frequately to prevent malfunction.
• Do not ush the unit to prevent electrocution.
• Do not operate the with wet hands to prevent electrocution.
• Clean the tler periodically, as heavy dust could lead to indoor oxygen decit.
• Wear gloves when cleaning lters and heat exchagners to avoid injury.
• When the unit is not to be used for long time, please cut o the power supply. Heavy dust poses re
hazard.
• Do not install the unit in the bathroom and other places with high relative humidity to prevent
electrocution.
• Do not install the unit where there is a re source or open re to prevent overheating or blaze .
• Do not install the unit where inammalbe gas could leak to avoid re hazard.
• Do not install the unit in chemical factories which produces acids, alkalis, organic solvents, coatings and
other harmful and corrosive gases, as they could lead to toxication or re.
• Provide enough space around the unit to allow the installation and maintenance personnel unrestricted
access to all service points.
To Next Page
Loading...
Need help?
General
