Wired Controller XK49
18
“ ” will light up.
4.3 Temperature Setting
Pressing “ ” or “ ” button in On status increases or decreases set temperature
by 1°C; holding “ ” or “ ” button increases or decreases set temperature by 1°C
every 0.3s. In Cooling, Fan, Heating, Dry mode, temperature setting range is
16°C~30°C.
Note:
①
Under Auto mode, the unit temperature can not be adjusted by “ ” or “ ”
button.
②
When the wired controller is connected with a Fresh Air Indoor Unit, fresh air
indoor unit code “FAP” will be displayed as shown below. Setting temperature
won’t be displayed and can’t be adjusted “ ” or “ ” button. The air outlet
temperature in cooling or heating can only be set in the parameter setting
status.
4.4 Fan Setting
Under On status, pressing FAN button can set fan speed circularly as:
Note:
①
In Dry mode, fan speed is low and can’t be adjusted.
②
When the wired controller is connected with a Fresh Air Indoor Unit, fan speed
of indoor unit will be high fan speed only. Fan speed of indoor unit can’t be
adjusted via “FAN” button
To Next Page
Loading...
Need help?
General
