Shenzhen Growatt New Energy CO.,Ltd
9
2.4 Emergency Responses
Manufacturer takes foreseeable risk scenarios into consideration and is designed to reduce hazards and
dangers. However, if the following situation occurs, do as below:
Description and action need
Avoid touch of leaking liquid or gas. If you touch the leaking
electrolyte, do as below immediately.
Inhalation: Evacuate the contaminated area, and seek medical
help.
Eye contact: Rinse eyes with flowing water for 15 minutes, and
seek medical help.
Skin contact: Rinse contacted area thoroughly with soap and
water, and seek medical help.
Ingestion: Vomiting, and seek medical help.
It’s hard for PACK systems ignite spontaneously. If the PACK
has caught a fire, do not try to extinguish the fire but evacuate
people immediately.
If PACK is flooded or submerged, do not access it. Contact
Growatt or distributor for technical assistance immediately.
Damaged PACKS are dangerous and must be handled with
special attention. They are no longer suitable for use and may
cause danger to people. If the PACK damaged, stop use it and
contact the Growatt or distributor.
3 Storage and Transportation
3.1 Storage Requirements
Place the PACK follow the identification on the packing case during storage.
Do not put the PACK upside down or sidelong.
The defective PACK needs to be separated from other PACKs.
The storage environment requirements are as follows:
1) Install the PACK in a dry and clean place with proper ventilation.
2) The storage temperature for a short week is between -20℃ to 50℃
3) If you store the PACK over a long period of six months, the storage temperature is
between-20°C to 45°C, relative humidity: 5%~95%RH.
4) Place the PACK away from corrosive and organic substances (including gas exposure).
5) Free from direct exposure to sunlight and rain
6) At least two meters away from heat sources (such as a radiator)
7) Free from exposure to intensive infrared radiation.
If the PACK has not been used for more than six months, it needs to be charged, The charging
procedure is as follows:
1) Identify the PACK that needs charging;