Haier AS35PBPHRA-PRE User Manual

1
2
3
4
5
9
10
11
12
13
14
15
16
17
8
22
23
24
25
26
19
20
21
18
7
6
1
2
3
4
5
67
8
1
3
2
1
2
4
3
3
EN
1.Mode display
2.Signal sending display
3.SWING display
4.FAN SPEED display
5.LOCK display
6.TIMER OFF display
TIMER ON display
7.TEMP display
8.Additional functions
display
9. TURBO/QUIET button
10. MODE button
11. I FEEL button
12. SWING left/right button
13. FAN SPEED button
14. HEALTH button
15. TIMER button
16. WIFI button
17. LIGHT button
Control the lightening and
extinguishing of the indoor LED
display board.
18. POWER ON/OFF button
19. ECO button
20. TEMP button
21. SWING up/down button
22. SLEEP button
23. EXTRA FUNCTION button
Function: A-B yard---> Healthy airow
position1--->Healthy airow position
2 --->10°C heating (If there is not the
10°C button) --->ºF/ºC transform
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions
25. RESET button
When the remote controller appears
abnormal, press this button 3s to
reset the remote.
26. 10 °C button

special heating
set function: 10 degree heating
maintaining

or SELF CLEAN button
Outdoor Unit
Loading of the battery
Indoor Unit Remote controller
Please be subject to the actual produce purchased the above
picture is just from your reference.
Note
●
The distance between the signal transmission head and the
receiver hole should be within 7m without any obstacle as well.
●
When electronic-started type uorescent lamp or change- over
type uorescent lamp or wireless telephone is installed in the room,
the receiver can to be disturbed in receiving the signals,so, the
distance to the indoor unit should be shorter.
●
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
●
If the remote controller can't run normally during operation, please
remove the batteries and reload several minutes later.
1.Remove the battery cover
2.Load the batteries as illustrated. 2 R-03
batteries, resetting key(cylinder); Be sure
that the loading is in line with the " + "/"-"
3.Load the battery, then put on the cover
back again.
Actual inlet grille may vary from the one shown in the manual
according to the product purchased
Hint

Remove the batteries in case won't be in use for a long
period. If there is any display after taking-out, just press reset
key.
4
1.Inlet
2.Air Purifying Filter(inside)
3.Display board
4.Emergency Switch
5.Outlet
6.Vertical blade (adjust left and
right air ow)
7.Horizontal ap (adjust up and
down air ow. Don't adjust it
manually)
8.Inlet grille
Parts and Functions
Display board
1.Signal receiver
2.Temp.display
3.Wi-Fi
4.Operation mode indicator
(lights up when the compressor is on.)
1.
OUTLET
2.
INLET
3.
CONNECTING PIPING AND ELECTRICAL WIRING
4.
DRAIN HOSE
QUIET
SLEEP HEALTH TURBOECO
Operation mode
Remote
controller
AUTO COOL DRY FAN HEAT
Operation mode
Remote
controller
AUTOLO MED HI
Display
circulated

Haier AS35PBPHRA-PRE Specifications

General

Brand	Haier
Model	AS35PBPHRA-PRE
Category	Air Conditioner
Language	English