WARNING!
Before first use
▶ Make sure there is no transport damage.
▶ Remove all packaging and keep out of children´s reach.
▶ Wait at least two hours (six hours for upright freezer) before in-
stalling the appliance in order to ensure the refrigerant circuit is
fully e cient.
▶ Handle the appliance always with at least two persons because it
is heavy.
Installation
▶ The appliance should be placed in a well-ventilated place. Ensure
a space of at least 10 cm above and around the appliance.
▶ WARNING: Keep ventilation openings, in the appliance enclosure
or in the built-in structure, clear of obstruction.
▶ Never place the appliance in a damp area or location where it
might be splashed with water. Clean and dry water splashes and
stains with a soft clean cloth.
▶ Do not install the appliance in direct sunlight or in the near of heat
sources(e.g. stoves, heaters).
▶ Install and level the appliance in an area suitable for its size and
use.
▶ Make sure that the electrical information on the rating plate
agrees with the power supply. If it does not, contact an electrician.
▶ The appliance is operated by a 220-240 VAC/50 Hz power sup-
ply. Abnormal voltage uctuation may cause the appliance to fail
to start, or damage to the temperature control or compressor, or
there may be an abnormal noise when operating. In such case, an
automatic regulator shall be mounted.
▶ Do not use multi- plug adapters and extension cables.
▶ WARNING: Do not locate multiple portable socket-outlets or
portable power supplies at the rear of the appliance.
▶ WARNING: When positioning the appliance, ensure the supply
cord is not trapped or damaged.
▶ Do not step on the power cable.
4
EN
Safety information
To Next Page
Loading...
Need help?
General
