Hayward AquaRite 100 User Manual

Problem Detected LED
With LED #8 With “MAX” LED
Reason Possible Action
No
Current to
Cell
Remove power to the AquaRite 100 for two
minutes and then re-apply to reset system
Turn on Super Chlorinate briefly then go back to
original setting
Inspect cell vessel and verify cell plates arefully
covered by moving water
Reason Possible Action
Cell Error
Remove power to the AquaRite 100 for two (2)
minutes and then re-apply to reset system
Make sure cell cable is secure and free of
damage, replace if necessary (GLXAQR100CABLE)
If error persists, replace thecell
(CCELL)
*Pages 49-52 will walk you through the proper steps to diagnose these errors
50

Hayward AquaRite 100 Specifications

General

Brand	Hayward
Model	AquaRite 100
Category	Water Pump
Language	English