Page 2
USE ONLY HAYWARD
®
GENUINE REPLACEMENT PARTS
WARNING: Electrical hazard.
Failure to comply with these instructions can result in
serious injuries or death.
THE EQUIPMENT IS INTENDED TO BE USED ONLY ON
PERMANENTLY CONSTRUCTED POOLS AND SPAS
WARNING – Disconnect/isolate the equipment from the electricity supply before any
installation/service/repair.
WARNING – All electrical wiring must be performed by a qualified and licensed electrical
contractor in accordance with all Local/State/Federal Government electrical regulations and
the latest edition of the AS/NZS 3000 Wiring Rules.
WARNING – Ensure that the device is plugged into a power outlet that is protected against
short-circuits. The device must also be powered via an isolating transformer or through a
residual current device (RCD) with a fixed residual operating current not exceeding 30 mA.
WARNING – Check that the supply voltage required by the product corresponds to the
voltage of the distribution network.
WARNING – To reduce the risk of electric shock, do not use an extension cord to connect the
device to the mains. Use a suitably rated GPO as per the standard AS/NZS 3000.
WARNING – Chemicals can cause internal and external burns. To avoid death, serious injury
and/or damage to equipment, wear personal protective equipment (gloves, goggles, mask,
etc.) when servicing or maintaining this device. This device must be installed in an adequately
ventilated place when equipped with the chemical feed options.
WARNING – Carefully read the instructions that appear in this manual and on the device.
Failure to comply with the instructions can cause injuries. This document must be given to the
pool owner who should keep it in a safe place.
WARNING – The appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
WARNING – Use only genuine Hayward replacement parts.
WARNING – If the power supply cord is damaged the device must not be used. The power
supply cord must be replaced by the manufacturer or similarly qualified persons to avoid any
danger.
To Next Page
Loading...
Need help?
General
