Page 3
USE ONLY HAYWARD
®
GENUINE REPLACEMENT PARTS
INTRODUCTION
The AquaRite+ is the most advanced salt water chlorinator for sanitising swimming pools and spas or pool/spa combinations on the market.
Not only is the AquaRite+ a salt water chlorinator that controls the filtration pump with a magnitude of different on/off timer features, but
with the addition of optional upgrade kits, it can measure and control the pH and ORP levels, control a heater and power an LED light, which
can all be done remotely with the optional remote display screen and/or the Wi-Fi module with free App.
The AquaRite+ requires a low concentration of salt (sodium chloride) in the pool/spa water and automatically converts the salt into free
chlorine which kills bacteria and algae in the water. The chlorine will revert back to sodium chloride after killing the bacteria and algae. These
reactions will continuously recycle virtually eliminating the need to add sanitising chemicals to your pool/spa. The only time that you may
need to add salt to the pool/spa water is when water is replenished due to back-washing, draining, or splashing out only (not evaporation).
The actual amount of chlorine required to properly sanitise a pool or spa varies due to bather load, rainfall, water temperature, and the
general cleanliness of the pool or spa. The AquaRite+ is suitable for treating most size residential pools up to 150,000 litres in a cool
climate and depending which size Hayward Turbo Cell is connected to the unit.
NOTE: Before installing this product as part of a salt water purification system in a pool or spa using natural stone for coping or for immediately
adjacent patios/decking, a qualified stone installation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and
maintenance of stone used around a saline pool with an electronic chlorine generator in your particular location and circumstances.
NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions where pool water is subject to excessive
evaporation and is not commonly diluted with fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator cell.
INSTALLATION
Components
1
2
4
5
6
7
1. Control Box
2. Turbo Cell
3. Cell Connector
4. Fuse 4.0 A
5. Power Cable
6. Flow Switch
7. 2 x Cable Glands
pH
Probe
Measuring
Chamber
Peristaltic
Pump
ORP Upgrade
Kit
Remote Display
Upgrade Kit
Wi-Fi Network
Upgrade Kit
Temperature
Probe Upgrade
Kit
Spa Flow
Switch
Upgrade Kit
Front View
Bottom View
pH Upgrade Kit
Oponal Upgrade Kits
3
7
To Next Page
Loading...
