Hettich AxisDrive Series User Manual

17
17
6. Commissioning
Commissioning includes the work that is required
so that an electrically adjustable bed / slatted bed frame
can be adjusted with the double drive.
Prerequisites for commissioning are:
 the electrical fittings are installed,
 the double drive is installed,
 the handset is installed.
For maintenance and repair work in special
areas (electrical engineering, etc.), only specialists
trained in the respective area must be used.
Observe the following safety notes!
6.1 Initial commissioning
Observe the following before initial commissioning of the
slatted bed frame:
Check that the slatted bed frame has been installed according
to the provisions named!
 Ensure that the moving parts can move unobstructed in
the required tolerances and that the safety clearances are
observed!
 Check the function of the safety devices!
Danger to life!
There is a danger to life from electric shock at
improper work at live parts!
Work at electrical equipment must only be
performed by authorised electricians. The
double drive must be powered down before
repair and cleaning!
Disconnect the power cable from the mains and
secure it against accidental reactivation.
Warning!
The housing of the double drive must not be
opened, removed or damaged.
Connection of self-constructed products to the
double drive is forbidden! Only use components
released by the manufacturer, since the device
may otherwise be damaged or destroyed!
Check for unusual sounds and heating when
adjusting the lying position even during
commissioning! If this is the case, take the
slatted bed frame out of operation. Have the
slatted bed frame repaired by a specialist
company and only take it into operation again
after repairs.
Danger
Warning
Note
Note

Hettich AxisDrive Series Specifications

General

Brand	Hettich
Model	AxisDrive Series
Category	DC Drives
Language	English