04
CHAPTER 2 PREPARATION
Charge Device
Plug in the included USB cable, and connect the device to the power supply via a power
adapter to charge the device. Do not use the USB-C to USB-C cable of other
manufacturers.
The power adapter (not included) should meet the following standards:
Output Voltage/Current: 5 VDC/2 A
Minimum Power Output: 10 W
Check the power indicator for the charging status:
Solid red: charging normally
Flashing red: charging exception
Solid green: fully charged
The device is equipped with the built-in battery. For the first charge, charge the
device for more than 3 hours when the device is turned on.
If the camera is not in use for an extended period and is over-discharged, it is
recommended to charge for at least 30 min before powering it on.
It is recommended to use the USB cable included in the package for both charging
and data transfer.
Power On/Off
Power On
Hold for over six seconds to turn on the device. You can observe the target when the
interface of the device is stable.
It may take at least 30 s until the device is ready for using after you power
on it.
Power Off
When the device is turned on, hold for about six seconds to power off the device.
2.2.1
Set Auto Power-Off
In the live view interface, press , and go to More Settings > Auto Power-off to set the
automatic shutdown time for device as required.
To Next Page
Loading...
Need help?
General
