HIKVISION DS-2AE714 User Manual

IR Speed Dome User Manual
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
2
Chapter 2 Getting Started
Before you start:
You can operate the speed dome using a control device. The control devices include the control
keyboards, DVRs, DVSs, etc. In this and the following chapters, operation of the speed dome by the
IE browser of a DVR is taken as an example.
Note: Please make sure that the baudrate, data bit and address of the speed dome have been
configured to the same as those of the control device. Please refer to Table 2-1 for details of the
configuration.
2.1 Power on Self-test Actions
After the power is connected, the IR dome performs a series of POST (power on self-test) which
includes the lens actions and the pan and tilt movements. After the power on self-test finished, the
system information displays for 2 minutes on the live view screen shown below.
ADDRESS 0
COM FORMAT 2400,8,1
PROTOCOL SELF ADAPTIVE
SOFT VERSION 1.00
HARD VERSION 1.00
BUILD DATE 12 08 31
PAN CHECKING...
Figure 2-1 System Information
Table 2-1 Description of System Information
System Info
Description
ADDRESS
The address of the speed dome. The default value is 0
COM FORMAT
The communication settings of the speed dome.
Baudrate(default 2400), data bit(8 digit) and stop bit(1 digit).
SOFT VERSION
The version of the software.
HARD VERSION
The version of the hardware.
BUILD DATE
The date when the program of the software is compiled.

HIKVISION DS-2AE714 Specifications

General

Brand	HIKVISION
Model	DS-2AE714
Category	Security Camera
Language	English