(2) Click the PTZ control buttons and direction buttons to pan, tilt, call the presets or zoom
in/out the speed dome to draw a movement path. The speed dome can automatically
memorize the path you operated as a pattern.
(3) Click IRIS+ again to save the pattern and exit edit mode.
Notes:
1. Remain Memo indicates the remaining memory of the speed dome for configuring the patterns.
When it reaches 0, no more patterns can be configured. You can also see the remaining
memory shown under PATTERNS menu as Space Remain.
2. The panning/tilting movements and the lens operations cannot be memorized simultaneously.
Preview the pattern.
Enter the PREVIEW menu to preview the current pattern.
Delete Pattern
Click IRIS+ to enter the Delete Pattern interface, and click IRIS+ to confirm the deletion.
Space Remain
Space remain refers to capacity of the speed dome to record the pattern
3.2.7 Configuring the Time Tasks
Purpose:
A time task is a scheduled dome action which can be configured to perform automatically at a
specific time.
Steps:
1. Move the cursor to enter the TIME TASK interface:
MAIN MENUS > DOME SETUP > TIME TASK SETUP
2. Choose the Task Number.
Steps:
(1) Move the cursor to TIMETASK SETUP and click IRIS+ to enter the edit mode.
(2) Click the up and down direction buttons to select the number of the task which is to be
configured.
(3) Click IRIS+ again to confirm and exit edit mode of this column.
Note: You can configure up to 8 tasks.
To Next Page
Loading...
Need help?
General
