HIKVISION DS-2DF7C445IXR-AEL(T5) User Manual

8.2.8 Set Tracking Parameters
Adjust the moon parameters of the device for beer target tracking performance.
Steps
1.
Go to Open Plaorm → Smart Event → Advanced Parameters .
2.
Oponal: Check Tuning Mode.
Note
Tuning mode is to display the informaon that helps debugging the funcon. This mode is
reserved for technical support.
3.
Set the Duraon.
The device stops tracking when it tracks a target uninterruptedly for the set duraon.
4.
Set the zooming control and other tracking parameters.
Zooming Control
Two modes are available. Controlled by target frame or by lt angle of the device.
By Tilt Angle
The device calculates the tracking zoom rao automacally according to the lt angle of
the device.
Note
The atude of the device aects the accuracy of this zooming control mode. For the
model with a built-in gyroscope, try to calibrate the atude if some zooming problems
happen during tracking. See Set Device Posion for instrucons.
By Target Frame
The tracked target has a virtual frame around. The device calculates a suitable zoom rao
according to the frame and the set Tracking Zoom Rao. Larger value means bigger zoom
rao.
Wait to Stop Tracking If Low Validity
The validity is an internal parameter that helps judge whether the device should keep
tracking or not. This parameter is the
waing me level before the device stops tracking
when the validity is low. Larger value means longer waing me.
Wait to Lower Tracking Speed If Low Validity
The validity is an internal parameter that helps judge whether the PTZ channel should lower
the tracking speed or not. This parameter is the
waing me level before the device lowers
the tracking speed when the validity is low. Larger value means longer waing me.
5.
Click Save.
Network Speed Dome User Manual
77

HIKVISION DS-2DF7C445IXR-AEL(T5) Specifications

General

Brand	HIKVISION
Model	DS-2DF7C445IXR-AEL(T5)
Category	Security Camera
Language	English