Network Video Recorder User Manual
28
5.3.3 Event
Motion Detection
Motion detection enables the video recorder to detect the moving objects in the monitored area
and trigger alarms. The device can analyze videos that contain human and vehicle, and discard
alarms which are not triggered by human or vehicle.
Steps
Note
If your device VCA Mode can be set as By NVR, this function would enabled by default. The
default detection area is full screen.
1. Go to Configuration → Camera → Event → Motion Detection.
Figure 5-10 Motion Detection
2. Select a camera.
3. Turn on Enable.
4. Set VCA Mode as By NVR or By Camera.
By NVR
The motion detection event will be analyzed by NVR. The device can analyze videos that
contain human and vehicle. Only the target of selected type (human or vehicle) will trigger
alarms, which can reduce false alarms that are caused by other objects.
By Camera
The motion detection event will be analyzed by camera.
5. Set the motion detection area.
To Next Page
Loading...
Need help?
General
