Conference Flat Panel User Manual
11
Chapter 4 Startup and Shutdown
4.1 Device Startup
4.1.1 Installed Without a Computer Box
Steps
1. Connect the device to power supply.
2. Turn on the power switch, the power indicator on the front panel will turn red.
3. Push the power button on the front panel to start up the device, the indicator will turn blue.
4.1.2 Installed with a Computer Box
Install the box when the device is disconnected from power and turn on the power switch after
the installation is finished. During the startup, the power indicator of the box will turn red and the
fan will start. After a beep sound, the power indicator will turn green and the computer is
switched on. Meanwhile, the power indicator on the front panel will turn blue which means the
device is switched on.
4.2 Eco Mode
Entering Eco Mode
Press the power button on the front panel to turn off the screen and enter Eco Mode.
Waking up the Device
Three ways to wake up the device:
● Press the power button on the front panel.
● Press the power-off button on the remote control.
● Touch anywhere on the screen twice.
4.3 Shutdown
● If the device is not installed with a computer box or the computer box is shut down, directly
switch off the power to shut down the device.
● If the device is installed with a computer box which is powered on, tap Start and choose
Shutdown, or press the power button on the computer box to shut it down (press and hold the
To Next Page
Loading...
Need help?
General
