HIKVISION DS-KH6350-WTE1 User Manual

Enter the device name, IP address, user name and the password of the camera. Edit port No.
and channel No.
Exit the page to save the sengs.
-
Select Open Network Video Interface to add the camera.
Enter the device name, IP address, user name and the password of the camera.
Exit the page to save the sengs.
3.3.7 Zone and Alarm Sengs
Zone Sengs
You can set the zone type, alarm type and delay me and other parameters of 8 zones.
Before You Start
Tap Sengs → → Shortcut Sengs , and enable Alarm.
Steps
Note
Arming status page and zone sengs page are hidden by default. You should enable alarm funcon
rst.
1.
Tap Sengs → → Zone Sengs to enter the zone sengs page.
Figure 3-24 Zone Sengs
Network Indoor Staon Conguraon Guide
23

HIKVISION DS-KH6350-WTE1 Specifications

General

Color	Yes
Connectivity technology	Wired & Wireless
Number of displays supported	1
Maximum number of cameras supported	-
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	128 GB
Flash memory	32 MB
Internal memory	128 MB
Alarm input channels	8
Operating system installed	Embedded LINUX
Package weight	683 g
Outdoor unit included	No
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	TFT
Product color	Black
Voice codecs	G.711a, G.711u
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, SIP, RTSP
Power consumption (typical)	8 W

Weight and Dimensions

Depth	21 mm
Width	175 mm
Height	113.5 mm
Weight	355 g