99
Note
You should disable the arming function in the Advanced Settings page. Or the AX PRO arming
with fault function cannot be valid.
Forced Arming
After enabled, when manual arming starts, if there are an active faults in a zone, the zone will
be automatically bypass.
System Status report
If the option is enabled, the device will upload report automatically when the AX PRO status is
changed.
Voice Prompt
If the option is enabled, the AX PRO will enable the text voice prompt.
System Volume
The available system volume range is from 0 to 10.
Audible Tamper Alarm
While enabled, the system will alert with buzzer for the tamper alarm.
Panel Lockup Button
Enable/disable the lockup button for the control panel.
Bypass on Re-Arm
While enabled, the zone with fault will be bypassed automatically when re-arming.
Polling Loss Times
Set the maximum duration for polling loss. The system will report fault if the duration is over
the limit.
Fault LED Stay On When Armed
When system is armed, the fault indicator is always on.
Ezviz Indicator
Enable the Ezviz indicator.
Arm LED Stay On
The arm LED is always on.
Motion Detector Restore
Motion detectors include all PIR detectors.
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference interferes
with communication. You can adjust the detection sensitivity.
Energy Save Mode
To Next Page
Loading...
Need help?
General
