3 Setting the Dome over the LAN
To view and configure the speed dome via LAN(Local Area Network), you need to connect the
network speed dome in the same subnet with your PC. Then, install the SADP or client software to
search and change the IP of network speed dome.
The following figure shows the cable connection of network speed dome.
Figure 3-1 Wiring over LAN
Set the IP address of the speed dome for accessing via LAN.
Steps:
1. To get the IP address, you can choose either of the following methods:
Use SADP, a software tool which can automatically detect network speed dome in the LAN
and list the device information like IP address, subnet mask, port number, device serial
number, device version, etc., shown in Figure 3-2.
Use client software to list the online devices. Please refer to the user manual of client
software for detailed information.
2. Change the IP address and subnet mask to the same subnet as of your PC.
Refer to the following introductions to set IP address with SADP software:
Search active devices online
Search online devices automatically:
After launch the SADP software, it automatically searches the online devices every 15
seconds from the subnet where your computer locates. It displays the total number and
information of the searched devices in the Online Devices interface. Device information
including the device type, IP address, port number, gateway, etc. will be displayed.
To Next Page
Loading...
Need help?
General
